I am interested in any suggestion, any feedback. Millumin 4.16c - MacBook Pro 16 inches 2021 - M1 Pro - RAM 32 GB - MacOS 12.3 Other than Millumin, MadMapper and Resolve, there isn't much installed on it. The Macbook is new and is only used for this show. The following attempts were unsuccessful: The fps indicator stays stuck at 50 fps even when the playback seems to be at 5 fps. So movie frames are synchronous to framerate (and all movie frames are rendered). However, if you run a movie at 50fps, it is better if your monitor works at the same refresh rate : 50hz. If you run movies at 24fps, 25fps or 30fps, no problem : Millumin will render all the frames. The jerks are visible in the Millumin interface. If the framerate is not stable, click on the Optimize button. Most of the media are quite long (10-15 minutes), sometimes the playback goes well from beginning to end (but unfortunately this is quite rare), usually when a clip starts to jerk, it lasts until the next one. I regularly observe stutter while playing a single 2400x2828px file at 50 fps encoded in ProRes 422. However for technical reasons, Millumin V1 does not work on macOS Catalina (or higher). Millumin V1 works from OSX 10.6 Snow Leopard to macOS 10.14 Mojave (included). Millumin V2 requires macOS 10.9 Mavericks (or higher). Millumin V3 requires macOS 10.11 El Capitan (or higher). I don't play more than two simultaneously (except during transitions). Millumin V4 requires macOS 10.14 Mojave (or higher). On the hardware side, I have a Macbook M1 Pro (detailed configuration below) which sends a 2160p50 signal to a Teranex AV (via an HDMI-HDBaseT Kramer 4K extender), the Teranex manages the quad SDI cut to send 3 x 1080p25 streams to the VPs.Ĭoncerning medias, I tried to adapt their resolution to the projection area, they are all below 4K. The "cyc+floor" canvas is re-injected via syphon and splitted on the 2 other canvases which are themselves, after processing (essentially colorometry and softcrop) sent via syphon to MadMapper to manage the warping and the soft edge. I've been struggling for two months to solve stuttering problems and I don't know what to try anymore, so here is an official call for help.įor a dance show with projection on cyc and floor (1 VP for the cyclo, 2 VP in softedge for the ground), I associate Millumin and MadMapper in the following way:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |